| Part Number | Description | Sources Available | Tool Request Qty |
|---|---|---|---|
| 700001 | PPG SEMCO 700001 MODEL 640 30 BEND, 6 LONG NOZZLE | 2 |
Partial Match
| Part Number | Description | Sources Available | Tool Request Qty |
|---|---|---|---|
| 01-1217-0000-10 | TOWBAR WITH OPTION 10, | 1 | |
| 01-1257-0000-10 | OPTION: 3 ID EYEBOLT, | 1 | |
| 066-01070-0001 | Dme Kn-63 / Honeywell | 1 | |
| 120780700001 | CMC TOOL | 1 | |
| 120TP-5700-001 | WING TROLLEY | 1 | |
| 18777-000-01 | PISTON | 1 | |
| 2700001 | TEST INSTRUMENTATION | 1 | |
| 27000013 | POWER SUPPLY UNIT | 1 | |
| 27000016 | EXTENDER CARD | 1 | |
| 27000017 | OVER/ UNDER VOLTAGE TESTER | 1 | |
| 35-92170-0001 | Rigging Gauge, Rudder | 1 | |
| 35-92270-0001 | ADAPTER HARNESS | 1 | |
| 35-93070-0001 | SHOP BUILT TEST SET | 1 | |
| 351-7000-01GSE | INLET COWL SLING | 1 | |
| 407-00001 | METER: REV,F, DC400A TEST SET | 2 | |
| 57000-01 | LOADER - DATA, CD-ROM, INDUSTRIAL RUGGED | 1 | |
| 57970-0001 | SLEEVE | 1 | |
| 60P2700001N001COF | BACKLASH MEASUREMENT FIXTURE | 1 | |
| 6260A7000-01 | PALLET, SLIDING TUBE HANDLING | 1 | |
| 700-00167-105 | THIS IS NOT A TOOL | Not Available | Not Available |
| 700-00168-001 | THIS IS NOT A TOOL | Not Available | Not Available |
| 70000-13100-041 | THIS IS NOT A TOOL | Not Available | Not Available |
| 7000016921 | SCREW | 1 | |
| 72P2700001N001COF | G600 EMP COMBINATION FIXTURE #3 | 1 | |
| 851-7000-010 | THIS IS NOT A TOOL | Not Available | Not Available |
| 85750700-001 | FLAP DRIVE TOOL | 1 | |
| 85750700-001-89 | FLAP DRIVE ADAPTOR | 3 | |
| 95-92070-0001 | Zero Setting Gauge, Rudder | 1 | |
| 98999700001 | BATTERY CHARGING-ANALYZER | 1 | |
| 98S2700001204D | CONTROL PIN | 1 | |
| 990-E1700-001 | THIS IS NOT A TOOL | Not Available | Not Available |
| A70-000-1 | WRENCH NUT MLG WHEEL | 1 | |
| AG7000-01 | REPRODUCER, VIDEO TAPE, USED ON B767 A/C 10 | 1 | |
| AJF170-000-100 | HELMET | 1 | |
| CE001370-0001 | Fixed frame handling tool | 1 | |
| CE001570-0001 | Segment alignment and assembly tool | 1 | |
| CE001770-0001 | Dummy PACT | 1 | |
| CE400370-0001 | BTAR / BRSU Tare System | 1 | |
| CFM56-3 ENGINE STAND CRADLE (Alternate to FB70000-1) | FZES3011 | 1 | |
| CG9000070-0001 | Fuel Vent Blanking Plug | 1 | |
| CP070000. 1697.50 | AIR OPERATED AXLE JACK | 1 | |
| D72D70000-111 | TOOL | 1 | |
| DC-700-001 | TEMP. SENSOR ADAPTER | 2 | |
| EM14700001A | SPECIAL TOOL | 1 | |
| ENSAXX-CE500570-0001 | Util | 1 | |
| F27537000-01 | TOOL | 1 | |
| F7XC205700001 | AILERON INSTALLATION PINS | 1 | |
| FA262-50700-001 | SEAL | 1 | |
| FB70000-1 | Engine Cradle CFM56-3 | 4 | |
| FB70000-1 MULTIPURPOSE CRADLE | CFM56-3 (OEM) ENGINE STAND CRADLE | 1 | |
| FB70000-1 MULTIPURPOSE CRADLE CFM56-3 | CFM56-3 (OEM) ENGINE STAND | 1 | |
| FB70000-1-100 | FWD TRUNNION (RH) CFM56-3 | 1 | |
| FB70000-1-101 | UNIBALL ASSY CFM56-3 AND 5C2 ENGINES | 1 | |
| FB70000-1-102 | BEARING HOUSING BACKING PLATE | 1 | |
| FB70000-1-103 | BEARING HOUSING BODYSAME AS FB70020-58 | 1 | |
| FB70000-1-104 | END CAP SECURING BOLT | 1 | |
| FB70000-1-105 | M6 X 15Lg C'sk SOC HD SCREW | 1 | |
| FB70000-1-107 | REAR TRUNNION PIN (AFT) | 1 | |
| FB70000-1-109 | TRUNNION CLAMP LOCKING PIN | 1 | |
| FB70000-1-110 | CLAMP ASSY HINGE PINSAME AS FB70010-92 | 1 | |
| FB70000-1-111 | SWING BOLT HINGE PINSAME AS FB70010-93 | 1 | |
| FB70000-1-112 | TOWBAR & SIDE STAY PIN | 1 | |
| FB70000-1-113 | CRADLE JACK PIN WITH LYNCH PIN AND CHAIN | 1 | |
| FB70000-1-117 | SWING BOLT, PLATED | 1 | |
| FB70000-1-128 | 03 X 20 LG SELLOC PIN | 1 | |
| FB70000-1-129 | COLLAR NUT, ZINC PLATED | 1 | |
| FB70000-1-130/131/132 | REAR SUPPORT BOLT, WASHERS & NUT ASSY | 1 | |
| FB70000-1-3 | SIDE MEMBER (-3 CRADLE) | 1 | |
| FB70000-1-57 | AFT SUPPORT ARM ASSY | 1 | |
| FB70000-1-59 | REAR TRUNNION CFM56-3 | 1 | |
| FB70000-1-60 | REAR ARM LOWER BUSH | 1 | |
| FB70000-1-61 | TRUNNION BUSH | 1 | |
| FB70000-1-63 | AFT TRUNNION BLOCK CFM56-3 | 1 | |
| FB70000-1-64 | LOCK RING | 1 | |
| FB70000-1-64/65 | LOCK RING AND CAP SCREW | 1 | |
| FB70000-1-68 | TRANSPORTATION BRACING STRUT | 1 | |
| FB70000-1-68-TUBE | STEEL TUBE 60mm x 5mm | 1 | |
| FB70000-1-68/71 | BRACING STRUT L/H | 1 | |
| FB70000-1-69 | TRANSPORTATION BRACING STRUT | 1 | |
| FB70000-1-70 | UPPER BRACING STRUT RH | 1 | |
| FB70000-1-71 | UPPER BRACING STRUT LH | 1 | |
| FB70000-1-82 | CLAMP ASSY RH CFM56-3 | 1 | |
| FB70000-1-83 | CLAMP ASSY LH CFM56-3 | 1 | |
| FB70000-1-84 | CLAMP SIDE PLATE CFM56-3 | 1 | |
| FB70000-1-87 | TOP BLOCK CFM56-3 | 1 | |
| FB70000-1-88 | TRUNNION CLAMP UPPER HALF RH CFM56-3 | 1 | |
| FB70000-1-89 | TRUNNION CLAMP UPPER HALF LH CFM56-3 | 1 | |
| FB70000-1-90 | TRUNNION CLAMP LOWER HALF RH CFM56-3 | 1 | |
| FB70000-1-91 | TRUNNION CLAMP LOWER HALF LH CFM56-3 | 1 | |
| FB70000-1-95 | FWD LEFT HAND TRUNNION ASSY | 1 | |
| FB70000-1-96 | FWD RIGHT HAND TRUNNION ASSY | 1 | |
| FB70000-1-97 | R/H TRUNNION END CAP | 1 | |
| FB70000-1-98 | Captive Cap HD Screw | 1 | |
| FB70000-1-99 | FWD TRUNNION (LH) CFM56-3 | 1 | |
| FB70000-1-FB70077-200 | CFM56-3 ENGINE STAND TRANSPORTATION DOLLY | 1 | |
| FB70000-1-ST | CFM56-3 STORAGE STAND | 1 | |
| FB70000-102 | CRADLE TO BASE PIN -3/-5/-7/V2500 | 1 | |
| FB70000-102-L | CRADLE TO BASE PIN -3/-5/-7/V2500 | 1 | |
| FB70000-102EL | CRADLE TO BASE PIN LOCK (35CM) EXTRA LONG | 1 | |
| FB70000-104 | TOWBAR STOWAGE PIN | 1 | |
| FB70000-105 | WHEEL ARM TOP PIN | 1 | |
| FB70000-106 | BUMP BAR ATTACH PIN | 1 | |
| FB70000-107 | PIN TOWBAR ATTACHMENT & SIDE BRACE | 1 | |
| FB70000-107A | PIN ASSY FOR BRACING & TOW BAR. | 1 | |
| FB70000-108 | CRADLE TO BASE PIN HINGED FWD LH. | 1 | |
| FB70000-109 | WHEEL ARM LOWER PIN | 1 | |
| FB70000-109M | WHEEL ARM LOWER PIN | 1 | |
| FB70000-110 | AFT ARM ASSY MULTI-PURPOSE CRADLE | 1 | |
| FB70000-112 | BRACING STRUT ASSY | 1 | |
| FB70000-113 | SPARES-AFTERMARKET JACK PIN 3/-5/-7/V2500/-5C2 | 1 | |
| FB70000-113J | JACK & PIN ASSY MULTIPURPOSE CRADLE | 1 | |
| FB70000-115 | PADS SHOCK ABSORBER | 1 | |
| FB70000-16 | AFT CROSSMEMBER (-3 CRADLE) | 1 | |
| FB70000-18 | SHEEVE BRACKET, -3 CRADLE | 1 | |
| FB70000-1A | MULTIPURPOSE CRADLE CFM56-3FRAME ASSY | 1 | |
| FB70000-1J | Multipurpose Cradle CFM56-3 | 1 | |
| FB70000-1J-500 | JACKING CUPS (x 2 off) AND BOX | 1 | |
| G1000700001-001 | PADS KIT, JACKING AIRCRAFT | 2 | |
| G1000700001-001-REV- | PADS KIT JACKING AIRCRAFT | 1 | |
| G1002700001-057 | BEARING REMOVAL INSTALLATION KIT | 1 | |
| G601R2700001-1 | TOOL | 1 | |
| G670070000-1 | UTILITY CRANE - ENGINE CHANGE | 1 | |
| H700-001 | COCKPIT COVER | 1 | |
| HAY50700001 | DIGI-MICRMTR 0-1" 0.00005" RES | 1 | |
| PYR-35-92170-0001 | RIGGING GAUGE, RUDDER | 1 | |
| RB700001 | TOOL | 1 | |
| SRN7700-0018 | SRN1224A 4A CHARGER | 1 | |
| STT051957000010 | SLIDE CALIPER | 1 |
Aviapool (Aviation Tool Pooling LLC) is a global company providing around the clock assistance for the planning, supply, and sourcing of tooling equipment to the commercial aviation marketplace.
We are making available to our customers a comprehensive one-stop solution in ensuring the right tooling equipment reaches you on time for your planned input needs. With a fully researched tooling database of over 600,000 items, across multiple aircraft types available to you, we are in a perfectly placed position to get you what you need on time and on budget.
We take your tooling requests, and source the items on your behalf. Just submit your items, and we do the rest.
