| Part Number | Description | Sources Available | Tool Request Qty |
|---|---|---|---|
| 11011 | CLECO SET 3/32 | 1 |
Partial Match
| Part Number | Description | Sources Available | Tool Request Qty |
|---|---|---|---|
| 00711011N | SHAFT ADAPTER | 1 | |
| 0110115 | TOOL | 1 | |
| 0721101-1 | BRACKETS | 1 | |
| 110-111 | Mitutoyo 110-111 Differential Screw Translator Micrometer Head .05" | 1 | |
| 110-112 | Mitutoyo 110-112 Differential Screw Translator Micrometer Head .05" | 1 | |
| 11011-36 | CUPLING - OXY QUICK DISCONNECT | 1 | |
| 11011001 | 405/2QR-1/4" QUICK RELEASE EXTN. 2" | 1 | |
| 11011002 | 405/6QR-1/4" QUICK RELEASE EXTN. 6" | 2 | |
| 11011005 | 405/14QR-1/4 QUICK RELEASE EXTN 14 | 1 | |
| 11011006 | 405/4QR-1/4" QUICK RELEASE EXTN.4" | 1 | |
| 11011013 | 405/13QR-1/4" QUICK RELEASE EXTN.13" | 1 | |
| 110111-03 | COUPLING-OXYGEN QUICK DISCONNECT | 5 | |
| 110111-14 | TESTPORT | 3 | |
| 110111-15 | Oxy Cplg Quick Disconnect | 11 | |
| 110111-36 | COUPLING - OXYGEN QUICK DISCONNECT | 8 | |
| 110111-37 | COUPLING OXYGEN | 1 | |
| 11011502 | 408QR/2 - SIZE 2 54MM/2" - 1/4"DR EXTENSION WITH RECESSED QR BUTTON | 1 | |
| 11011504 | 408QR/4 - SIZE 4 102MM/4" - 1/4"DR EXTENSION WITH RECESSED QR BUTTON | 1 | |
| 11011506 | 408QR/6 - SIZE 6 150MM/6" - 1/4"DR EXTENSION WITH RECESSED QR BUTTON | 1 | |
| 11011513 | 408QR/13 - SIZE 13 330MM/13" - 1/4"DR EXTENSION WITH RECESSED QR BUTTON | 1 | |
| 11011514 | 408QR/14 - SIZE 14 356MM/14" - 1/4"DR EXTENSION WITH RECESSED QR BUTTON | 1 | |
| 110118-03 | ADAPTOR (TWO POSITION VALVE) | 1 | |
| 1101181 | TOOL | 1 | |
| 1110-1100 | JACK - TRIPOD | 1 | |
| 16A11011-1 | SLING ASSEMBLY WING HOISTING | 1 | |
| 16A11011-3 | SLING ASSEMBLY WING HOISTING | 1 | |
| 1930-110-110 | CASE PELICAN | 1 | |
| 206-240-001-1011 | LIFT TOOL | 1 | |
| 211011 | WASHER | 1 | |
| 21110112 | STUD PROBE AIRBUS | 1 | |
| 21110114 | LOAD MASTER KIT AIRB | 1 | |
| 21110119 | LOAD MASTER KIT AIRB | 1 | |
| 21110119-P-FA | LOAD MASTER KIT AIRB | 1 | |
| 3161101-1 | Tube | 1 | |
| 411-011 | EXTENDED COCKPIT COVER (goes back to 1st cabin window) | 1 | |
| 41101111 | 240.11MM-7/16"-RATCHET WRENCH 11mm-7/16" | 1 | |
| 43011011 | 29.10.X.11-10x11 DBL END FLEXI-JOINT SPNR | 1 | |
| 4621101100 | GAUGE | 1 | |
| 535110110 | WORKING STAIR WITH 10-ALU-STEP | 1 | |
| 58111-011 | VALVE | 1 | |
| 58211011 | 731/10.11-11mm OPEN END INSERT TOOL 9X12 | 1 | |
| 59011011 | 70.VK.502.1/2-1/2"X1/2" CALIBRATING SQ DRIVE | 1 | |
| 601101-101 | CABLE ASSEMBLY, ELECTRICAL | 1 | |
| 611-0110 | ARTEX 110/C406 SERIES PROGRAMMING CABLE | 1 | |
| 611-0111 | CABLE, C406-N/PA SERIES PROGRAM | 4 | |
| 611-0112 | ME406 SERIES PROGRAMMING CABLE- HANDHELD PROGRAMMER | 1 | |
| 731/10.11 | 11mm OPEN END INSERT TOOL 9X12 | 1 | |
| 810-1101130001-1 | AILERON TRIM TAB TRAVEL BOARD (BEECHCRAFT CORP) | 1 | |
| 831101-1 | PULLER, LOW PRESSURE TURBINE SEAL | 1 | |
| 8426 1101 13 | PISTOLET À RIVER CHAMPION RRN11P-02 | 1 | |
| A11011 | GUIDE-CONE | 2 | |
| A27110-11 | SPACER | 1 | |
| AF-3110-1.120/1.240/FX | ADJUSTABLE FLEXIBLE MANUAL BOLT HOLE "X"-PROBE WITH A COLLAR, 25-500KHz REFLECTION, 1.120"-1.240" OD, 9.0" WORKING LENGTH, SUPPLIED WITH A TRIAX FISCHER CONNECTOR. Includes Test Report and Certificate of Conformance. | 1 | |
| AT110-11 | REAR PLATE | 1 | |
| BH9011011 | POWER-PRO 18 BT FRAME RACK | 1 | |
| BR61-101/103 | AIR CONDITIONING TEST SET | 1 | |
| BS140110110APU | APU, CONTAINER | 1 | |
| C42P40110-11 | KIT ANTI-ICING | 1 | |
| CT3110-111 | HAMMER | 1 | |
| CT3110-113R | ANVIL ASSEMBLY | 1 | |
| CT3110-116A | PLANET GEAR. | 1 | |
| CT3110-118A | LABEL SET | 1 | |
| CTJ3110-118A | LABEL SET, CTJ3110 | 1 | |
| ES61110-11 | THIS IS NOT A TOOL | Not Available | Not Available |
| F11011-113-101 | Insert, Curved Edge | 1 | |
| F11011-113-102 | Insert, Curved Edge | 1 | |
| FB70-025-A330-91/101/102 | RETAINING PIN ASSY | 1 | |
| FSR-1501-10110A | FORCEMATE REAMER, .3240 CUTTER/.3090 PILOT (CLASS 2) | 1 | |
| FSR-1911-10110A | .2786 REAMER / .2620 PILOT (1ST OVERSIZE) | 1 | |
| G5B3411011 | TOOL | 1 | |
| G600-561101-1 | WINDSHIELD WINDOW SLING | 2 | |
| G601-291101-1 | KIT, BLANKOFF, ENGINE DRIVEN PUMP | 1 | |
| G601R241101−1 | Support Fixture − IDG | 3 | |
| G601R281101-11-REVB | PIN (DOWEL) | 1 | |
| G601R281101−1 | Tool − Fuel Drain−Valve Removal (2 Pins) | 3 | |
| G601R321101-1-REVNC | WRENCH - MLG PINTLE PIN NUT | 1 | |
| G601R321101−1 | Wrench − MLG Pintle Pin Nut | 7 | |
| G601R521101-1 | ASSEMBLY TOOLS | 1 | |
| G601R541101-1-REV- | SLING NOSE COWL | 1 | |
| G601R541101-11-REV- | PLATE | 1 | |
| G601R541101−1 | Sling − Inlet Cowl Removal and Installation (Alternate procurement P/N : ACS87002) | 4 | |
| G601R571101-101 | SPOTFACE, TRUNNION | 1 | |
| G604-281101-1 | KIT, FUEL TANK, VENTING | 4 | |
| G670−711101−101 | Nacelle Closing Tool | 1 | |
| G670321101-1 | SLEEVE - MLG AXLE PROTECTION | 2 | |
| G698−321101−101 | Sleeve − MLG Axle Protection | 1 | |
| G700-301101-1 | Drill Fixture - Wing Anti-Ice Sensor | 1 | |
| G700-301101-1/-2 | Drill Fixture - Wing Anti-Ice Sensor | 1 | |
| G700-381101-1 | ADAPTER, POTABLE WATER | 4 | |
| G700−271101-1 | KIT - AILERON RIGGING SIGHT GAUGE | 4 | |
| GBS3411011 | AIR DATA SET TEST | 1 | |
| GMIET110-1 (120V) | FOLDABLE OVEN / HEAT GUN / CONNECTOR FOR ANITA CONTROL | 1 | |
| GSB1011011 | COVERS - ICE DETECTION PROBES FOR P/N 511081 AND 510920−1 | 1 | |
| GSB3411011 | TEST SET-AIR DATA (PITOT TESTING) | 3 | |
| GSB34110111 | PITOT STATIC TEST SET | 1 | |
| GSB34110111/DSP1000 | TEST SET PITOT STATIC | 1 | |
| HC1101-1 | VALVE: NEEDLE, | 1 | |
| HC110110E52 | "HEAT BLANKET 11""X11"" | 1 | |
| HC110110E52E | "HEAT BLANKET 11""X11"" | 1 | |
| HC110110E52E1 | "HEAT BLANKET 11""X11"" | 1 | |
| IB-28-11-01-1 | UTIL | 1 | |
| IWLB-CBC-1-1011F/S | LB Nosecap replaced by New P/N CBC-11-10F/S | 1 | |
| JHW11011 | HI POL-WRENCH 9 6-14MM | 1 | |
| K51101-101 | SKIN FITTING TOOL | 1 | |
| K51101-105 | HOIST ASSEMBLY | 1 | |
| K51101-107 | SLING ASSEMBLY,RA-DOME | 1 | |
| K51101-115 | ASSEMBLY | 1 | |
| M110-110 | ENGINE COVERS (set of 2) | 1 | |
| M110-115 | INSULATED ENGINE COVERS (set of 2) | 1 | |
| M83461-1-011 | THIS IS NOT A TOOL | Not Available | Not Available |
| M8791-1-011 | RING | 1 | |
| N110-11-35-178GF | BAG | 1 | |
| NAS1611-011 | O-RING | 1 | |
| NAS1611-011A | PACKING | 1 | |
| NAV1611-011 | TOOL | 1 | |
| NDT1101-100-MB | Boeing Standard, .100 over .050, Magnetic Steel Bolts such as BACB30NE or BACB30NF or equiv | 1 | |
| NDT1101-100-MR | Boeing Standard, .100 over .050 | 1 | |
| NDT1101-100-NMR | Boeing Standard, .100 over .050 | 1 | |
| NDT1101-160-MB | Boeing Standard, .160 over .080, Magnetic Steel Bolts such as BACB30NE or BACB30NF or equiv | 1 | |
| NDT1101-160-MR | Boeing Standard, .160 over .080 | 1 | |
| NDT1101-160-NMR | Boeing Standard, .160 over .080 | 1 | |
| NEC-3110-1.120/1.240/FX | PROBE | 1 | |
| PWA81101-1 | BASE-DEOILER GEARSHAFT | 1 | |
| RA11-01-12 | ADAPTER M.12X1/AN | 1 | |
| RL11011 | NOZZEL FOR 442. - 1.4MM | 1 | |
| RSMK-35-2-10-1101-100 | Probe RSMK-35-2-11,01-100 | 1 | |
| STY110110 | SANDG STICK 10IN FORD | 1 | |
| TCS12025-13110/11 | TCS FOAM SET | 1 | |
| TESA-00110113 | Tesa 00110113 Set of 4 ISOMASTER micrometers 0-100mm | 1 | |
| TMH RA11-01-12 | ADAPTER M.M12X1-M.JIC7/16 | 3 | |
| TMY20-71-101-1 | LH ENGINE AND NACELLE | 1 | |
| WAS6311-0116 | BUSHING | 1 |
Aviapool (Aviation Tool Pooling LLC) is a global company providing around the clock assistance for the planning, supply, and sourcing of tooling equipment to the commercial aviation marketplace.
We are making available to our customers a comprehensive one-stop solution in ensuring the right tooling equipment reaches you on time for your planned input needs. With a fully researched tooling database of over 600,000 items, across multiple aircraft types available to you, we are in a perfectly placed position to get you what you need on time and on budget.
We take your tooling requests, and source the items on your behalf. Just submit your items, and we do the rest.
